Sentry360 IS-IP290 Manuel d'utilisateur télécharger pdf (Page 7)

2 Camera Cabling

Please follow the instructions below to complete IS-IP290 connection.

2.1 Connect Power

Please refer to Section: Connectors. Alternatively, connect the Ethernet cable to

the camera’s PoE port and plug the other end of the cable into a PoE switch.

NOTE: If using PoE, make sure Power Sourcing Equipment (PSE) is in

use in the network.

2.2 Connect Ethernet Cable

Use of Category 5 Ethernet cable is recommended for network connection; to

have best transmission quality, cable length shall not exceed 100 meters.

Connect one end of the Ethernet cable to the RJ-45 connector of the IS-IP290,

and the other end of the cable to the network switch or PC.

NOTE: In some cases, you may need use an Ethernet crossover cable

when connecting the IS-IP290 directly to the PC.

Check the status of the link indicator and activity indicator LEDs; if the LEDs are

unlit, please check LAN connection.

Green Link Light indicates good network connection.

Orange Activity Light flashes for network activity indication.

2.3 Connect Alarm I/O

The camera equips one alarm input and one relay output for alarm application.

Refer to alarm pin definition below to connect alarm devices to the IS-IP290 if

needed.

1. Output+

2. Output-

3. Input+

4. Input-

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Pas de commentaire

Sentry360 IS-IP290 Manuel d'utilisateur Page 7